Roger's Temperature Tower Program.

Welcome to Roger's Temperature Tower Program. I created this program so that all those who 3d print things could easily create temperature towers. It takes Gcode as an input and inserts temperature reduction commands at relevant points based on the height of the object. That way, the temperature is reduced by the specified interval as the print progresses.

Important note: ***Use this program at your own risk!*** It is still in development at the moment. It may produce unsafe output, produce unexpected output, fail, crash, or otherwise not perform as expected at any time. You are responsible for manually checking the gcode that it produces before you give that gcode to your printer! If you don’t know how to manually check your gcode to ensure that it is safe to give to your printer, please learn how to do that before attempting to use this program! This is not an optional step. Sending incorrect gcode commands to your 3d printer could potentially cause it to catch fire! Do not underestimate the importance of manually checking the output of this program!

Input:

Decrease temperature by:

Start Temp in Degrees C:

End Temp in Degrees C:

Ignore the first:

Output: